1 - Conecte o módulo LDR à protoboard. 2 - Conecte o módulo LDR ao Arduino utilizando 3 jumpers: 3 - Conecte o pino GND do módulo LDR ao pino GND do Arduino. 4 - Conecte o pino VCC do módulo LDR ao ...
The Arduino TCS3200 sensor is a reliable currency detector that accurately detects and identifies various currencies based on their unique color patterns, making it an essential tool for automated ...
Here is the schematic diagram of a Human-following robot circuit. This design incorporates three ultrasonic sensors, allowing distance measurements in three directions front, right, and left. These ...
In this project, we create a joystick-controlled laser by connecting two servos to a joystick and using this setup as a pan-and-tilt controller for a laser pointer. The following is excerpted from the ...
I have made considerable progress on this project. I withdraw my initial assessment that this is a dead end. Read on. A friend is very involved with the support of local walking trails. His group ...
Rutronik Adapter Board RAB7 is an open-source hardware Arduino shield designed for AI-powered Sensor Fusion with seven environmental and inertial sensors from Bosch, Infineon, and Sensirion. The ...
Today, We will review the Cytron Maker Uno RP2040 development board combining the Arduino UNO form factor with the Raspberry Pi RP2040 microcontroller that makes it programmable with the Arduino IDE ...
The YouTube channel DIY Builder has published and created a DIY Arduino laser engraver which is powered by an Arduino Nano development board and is fitted with a 200-250mW 650nm Laser Module. Check ...
[Philip]’s Laser control Arduino shield. [Philip Nicovich] has been building laser sequencers over at the University of New South Wales. His platform is used to sequence laser excitation on his ...
Results that may be inaccessible to you are currently showing.
Hide inaccessible results
Feedback