A DIY project from a YouTuber presents the latest version of his 7 Segment Clock, v3.2C. This tabletop clock is built using 3D-printed parts and powered by an Arduino ...

This is a modification of the popular AccelStepper library that runs the motors using timer interrupts instead of polling them in the main loop. This allows for more precise step timings and running ...

⇒ UART Configuration : One of the most powerful aspects of the TMC2209 is its single-wire UART interface. With UART, you can configure motor current, microstepping resolution, operating modes, and ...

grbl is stepper motor controller firmware for three-axis cnc machines, intended to run on Arduinos with a motor driver add-on board. Engineer in Wonderland cnc-related blogs are indexed here It is the ...

🚀 Getting Started: On the Arduino Side: Upload stepper_control.ino to your Arduino using the Arduino IDE. Connect the stepper motor to pins 8-11. Adjust stepsPerRevolution and motorRunTime if needed.

It’s fair to say that building electronic gadgets is easier now than it ever has been in the past. With low-cost modular components, there’s often just a couple dozen lines of code and a few jumper ...

Makers, developers and Arduino enthusiasts searching for silent stepper drivers with high resolution encoders which are also Arduino compatible. May be interested in the new range of uStepper S line ...

The Teensy platform is very popular with hackers — and rightly so. Teensys are available in 8-bit and 32-bit versions, the hardware has a bread-board friendly footprint, there are a ton of Teensy ...

I have been pleasantly surprised how quickly Arduino’s language and IDE can be understood enough to do something useful – occasional hours found over a couple of weeks. Over the weekend, an old ...