* sketch started running on the Arduino. * To eliminate a lot of wires, in this sketch we'll use an I2C backpack to * drive the display. * This sketch was written by Peter Dalmaris for Arduino Step by ...

I would like to build an analogue clock using old fashioned Voltage meters to display the hour, minute and seconds.Using a networked Arduino or PICduino (or other controller), this shield provides a ...

Clock built from DIY 7-segment RGB LED modules, see related projects. -----CLOCK BASE----- 1 Arduino Nano 328P 1 Neo6M GPS Shield 1 DS3231 RTC Shield 1 Switch summer winters gmt 1 LDR 1 BP Reset RTC ...

This is an highly accurate clock & calender module as a Break-out Board (BoB). I use an RV3029-C2. C2 is a 5 mm SMD. The design is very simple. The PCB is 30 x 25 mm. It is based on an idea from ...

The interfacing between the Arduino with I2C is being explained in this project. The interfacing between the Arduino with I2C is being explained in this project. One good thing about using the readily ...

Tested with a couple of examples. Did find that Sparkfun recommended running at a I2c Clock of 350khz instead of 400khz for reliable operation: MCU keeps resetting the sensor · Issue #2 · ...

The new ASX00073 UNO SPE shield from Arduino is now being shipped by authorized distributor Mouser Electronics.

Mouser Electronics has announced that is now shipping the new ASX00073 UNO SPE shield from Arduino. The ASX00073 shield provides advanced connectivity to new and existing projects with Single Pair ...

This articles describes how you can use I2C (TWI) communication, Arduino and temperature sensors to measure 3 different temperatures. It can be very helpful when you want to measure the outside, ...