The LED should be connected to GPIO25 through a current limiting resistor (100–400 Ω). Connect the CAN transceivers to 3.3 V and GND and wire the signals as defined in menuconfig (defaults are ...

The following commands will build the project. The project must be built upon the device on which the ESP32 Microcontroller is connected. In the case of the non-secure implementation, the ...

We’ve seen tons of projects lately using the ESP32-C3, and for good reason. The microcontroller has a lot to offer, and the current crop of tiny dev boards sporting it make adding a lot of compute ...

Abstract: This paper presents a design scheme for a two-wheel self-balancing car based on dual-core control using STM32 and ESP32. High real-time balancing control duties are accomplished with the ...

Unexpected Maker has recently released the Series[D], a lineup of four new ESP32-S3 development boards: the EdgeS3[D], TinyS3[D], FeatherS3[D], and ProS3[D]. The boards feature dual antenna support ...

If you are in the need for an open source audio development platform powered by ESP32 might be worth your while checking out the new Loud ESP board and touchscreen interface currently available to ...

Designed by Namnam in Vietnam, the ESP32 Modbus gateway is built to communicate with PLCs and industrial sensors over Modbus RTU (RS-485) or Modbus TCP/IP (Ethernet/Wi-Fi). Designed for use in farms, ...