grbl is stepper motor controller firmware for three-axis cnc machines, intended to run on Arduinos with a motor driver add-on board. Engineer in Wonderland cnc-related blogs are indexed here It is the ...

It’s fair to say that building electronic gadgets is easier now than it ever has been in the past. With low-cost modular components, there’s often just a couple dozen lines of code and a few jumper ...

For his entry into the 2019 Hackaday Prize, [Tobius Daichi] is working on adding some motion control capabilities to everyone’s favorite Linux SBC. His 3+Pi board attaches to the Raspberry Pi’s GPIO ...

In Part II, we covered motor driving techniques, as well as various considerations to achieve smooth noise-free responsiveness.In this final part of the article, we’ll cover implementing motor control ...

A new motor driver featuring pulse-width modulation (PWM) and serial interfaces ensures quiet and robust motor operation in industrial and consumer applications. The motor driver IC, supporting both ...

Nanotec has introduced a driver for stepper and brush-less dc (BLDC) motors with sensor-less closed-loop and field-oriented control (FOC). Intended for steppers from NEMA 14 to NEMA 34 and BLDC motors ...