This project uses an HC-SR04 ultrasonic sensor to measure how close an object is. A buzzer and LED react depending on the distance, similar to a car parking sensor. < 10 cm → buzzer and LED stay on.

In this project I have created a code for an Ultrasonic Sensor in the Arduino IDE. If an object is present within 10cm of the sensor then buzzer will work.

In this tutorial, we'll guide you through interfacing an Arduino with an ultrasonic sensor to measure distance and show it on the Serial monitor. We'll start by explaining how to interface the ...

Here is the schematic diagram of a Human-following robot circuit. This design incorporates three ultrasonic sensors, allowing distance measurements in three directions front, right, and left. These ...

While early scientists and inventors famously underestimated the value of radar, through the lens of history we can see how useful it became. Even though radar uses electromagnetic waves to detect ...

In this experiment we are going to work with a sensor which is a resistor that depends on light. In a dark environment, the resistor will have a very high resistance. As photons (light) land on the ...

Abstract: An advanced blind assistance device integrates an ultrasonic sensor, Arduino UNO board, buzzer, and GSM module to create a cost-effective solution for enhancing the safety and autonomy of ...

Abstract: Early stage failure signals of rotating machinery are weak, and only high-sensitivity sensors can detect the mechanical damage status. This article proposes a design method for a highly ...