The word LiDAR, the ‘Li’ meaning ‘light’ indicates a device for optoelectronic echolocation. Instead of radio frequencies, the Lidar transmits a pulsed laser beam, the echo of which allows the ...

Het woord LiDAR, waarin "Li" staat voor "light", staat voor een opto-elektronisch apparaat voor echolocalisatie. In plaats van radiogolven zendt een lidar een pulserende laserstraal uit. Met de ...

[over9k] used his Arduino to set up a laser trip wire. The laser is mounted along side the Arduino, reflects off of a mirror, and shines on a photoresistor that interfaces via a voltage divider. The ...

In this project, we create a joystick-controlled laser by connecting two servos to a joystick and using this setup as a pan-and-tilt controller for a laser pointer. The following is excerpted from the ...

The YouTube channel DIY Builder has published and created a DIY Arduino laser engraver which is powered by an Arduino Nano development board and is fitted with a 200-250mW 650nm Laser Module. Check ...

Lasers are some of the coolest devices around. We can use them to cut things, create laser light shows, and also as a rangefinder.[Ignas] wrote in to tell us about [Berryjam’s] AMAZING write-up on ...

PREMSTAETTEN, Austria--(BUSINESS WIRE)--ams (SIX: AMS), a leading worldwide supplier of high performance sensor solutions, today announced that its low-power IR VCSEL laser emitter, the PMSIL, is ...

Jon Bumstead has created an awesome Arduino powered 13 note midi harp after receiving funding from the optics group Spectra at Washington University in Saint Louis. Watch the video below to learn more ...