[Sebastian] and [Stefan Shütz] had a ISEL EP1090 CNC machine at home, sitting unused, and they decided to bring it to life. With pretty good mechanical specs, this CNC looked promising – alas, it was ...

grbl is stepper motor controller firmware for three-axis cnc machines, intended to run on Arduinos with a motor driver add-on board. Engineer in Wonderland cnc-related blogs are indexed here It is the ...

This homemade CNC machine is the second version which uses mostly off the shelve parts where every part is allowed for some adjustments and the different design makes it easier to be built. The main ...

The open-source grbl project has produced software that allows an Arduino to control a three-axis CNC machine – it is the software within ‘3018’ and related low-cost Chinese-made CNC desktop routers.

Using a little Arduino hardware and programming a new CNC printing machine has been created to help bring Batik designs to life. Batik is a fabric decoration technique where wax is applied by hand to ...

With the continuing manufacture of new computers, there is a clear and obvious trend of the parallel port becoming less and less common. For our younger readers; the parallel port is an interface ...