Today, we’re assembling and wiring a 3D printed Arduino-based pistol-grip radio transmitter that operates entirely based on Arduino-compatible electronics and is intended for anyone looking to control ...

The idea is to use the Arduino to "read" the radio's original controls and translate their volume, tuning, and band settings to the SI chip. An NE55C is used to translate the tuning capacitor setting ...

It's a complete product development, of a cost effective radio transmitter and receiver utilizing Arduino and NRF24 tranceiver module. I started with drawing the schematic, then I did component ...

Arduino enthusiasts may be interested in a new thumb-sized radio-equipped Arduino Leonardo development board created by Doug Lyon.

Want to know how to interface an Arduino with a Radio Control Transmitter? Read on to see how. Signals from the Arduino can be sent to the transmitter as a result of this interface. The arduino signal ...

Explore ham and Arduino in the book, Arduino for Radio Applications, by Glenn Popiel. It's a must-have guide for amateur radio enthusiasts.

This article describes the construction of a simple Arduino RFID Access control DIY (Do It Yourself) Project using Arduino UNO and a RFID reader module (EM-18) to control an LED and a Relay. Circuit ...

Because some hardware setup is required to build up a functioning radio, an Arduino can be used to supply the voltage and control the radio chip. The 3.3-V power can be taken from the Arduino’s ...

A trainer cable for the RC transmitter had to be made to connect the radio of the student to the teacher so that the model can have share control. For the Arduino end of the cable, a little connector ...

So [Todd] has set out to build an Arduino frequency counter for a Kenwood TS-520S HF ham radio. This post (and the video found after the break) doesn’t cover the entire project.