Now, everything’s set up, so click the right-facing arrow near the top-left corner of the Arduino IDE window to upload the program to the board.

At the end of the video, I go through the initial set up in the Arduino IDE and run a simple sketch. The Arduino 101 and Genuino 101 are now available to purchase priced at €28.65.

Description: Order your pcb design at JLCPCB: $2 for 10pcs PCBs (24 hours turnaround time). up to $20 shipping discount on ...

This post discusses how I integrated a regular microphone into an Arduino setup for some serious audio experiments. I used a prewired module which holds a MAX9814 single chip microphone amplifier with ...

This Arduino Uno setup can be powered by a 6F22 9V battery or other suitable power source, but it is up to you. The next piece of hardware is a dual-channel, low-trigger, 5V relay module. This relay ...

An Arduino with 40 lines of code, a temperature resistor, and servo are all that’s truly needed to save some dough with this thermostat by [Peter Hamilton]. LEDs and a potentiometer are added… ...

The “N” in CAN stands for network, after all. The trick is to create a device ID for each desired CANSerial interface, which is done in his library using the usual Arduino setup step.

I have been pondering how to quickly and accurately manually set up a 16bit binary number in an Arduino (or other microcontroller). This problem has arisen since my (mostly) lovely FY6900 DDS signal ...