If Stepper is to agressively timed the needle bounces off the endpoint, this occurs at 250 microseconds. At 500 Microseconds the bouncing does not occur, but the movement is noisy. command bytes ...

With PWM units in Arduino Due (SAM3X8E), this library can generate pulses suitable for rotating the stepper at a desired speed. This library is a wrapper for antodom/pwm_lib. I would like to thank Dr.

⇒ UART Configuration : One of the most powerful aspects of the TMC2209 is its single-wire UART interface. With UART, you can configure motor current, microstepping resolution, operating modes, and ...

Stepper motors use a cogged wheel and electromagnets to rotate the wheel one ‘step’ at a time. Each HIGH pulse sent to the A4988 stepper driver energises the coil, attracting the teeth closest to the ...

[Neumi] over on Hackaday.IO wanted a simple-to-use way to drive stepper motors, which could be quickly deployed in a wide variety of applications yet to be determined. The solution is named Ethersweep ...

It’s fair to say that building electronic gadgets is easier now than it ever has been in the past. With low-cost modular components, there’s often just a couple dozen lines of code and a few jumper ...

Makers, developers and Arduino enthusiasts searching for silent stepper drivers with high resolution encoders which are also Arduino compatible. May be interested in the new range of uStepper S line ...

Leonardo Russo’s ArduinoSimulator is an open-source Arduino Simulator written in JavaScript that runs code directly in your web browser and shows the serial output and digital/analog pins status for ...