A minitensile machine is a table top tensile machine for testing samll specimen. This set of sketches were developed to control the stepper motor drilving the ball screw pair through a set of gears.

This Arduino program is refered from: https://github.com/tuenhidiy/CNC-PLOTTER-FROM-DC-MOTORS-AND-OPTICAL-ENCODERS Requires the L298N library by Andrea Lombardo found ...

⇒ UART Configuration : One of the most powerful aspects of the TMC2209 is its single-wire UART interface. With UART, you can configure motor current, microstepping resolution, operating modes, and ...

Today, we are going to investigate the TMC2208 stepper motor driver, a commonly used driver module that performs well with 2-phase bipolar stepper motors. The TMC2208 module is manufactured by ...

Stepper motors are a mainstay in precision control systems, valued for their simple open-loop operation and high torque at low speeds. Commonly found in CNC machines, 3D printers, and robotics, they ...

grbl is stepper motor controller firmware for three-axis cnc machines, intended to run on Arduinos with a motor driver add-on board. Engineer in Wonderland cnc-related blogs are indexed here It is the ...

[Neumi] over on Hackaday.IO wanted a simple-to-use way to drive stepper motors, which could be quickly deployed in a wide variety of applications yet to be determined. The solution is named Ethersweep ...

For his entry into the 2019 Hackaday Prize, [Tobius Daichi] is working on adding some motion control capabilities to everyone’s favorite Linux SBC. His 3+Pi board attaches to the Raspberry Pi’s GPIO ...

Our project focuses on improving the control system for an electric-vehicle motor, previously used in a racing competition by the UDA E-Team (short for Universidad del Azuay, Ecuador). This project ...