If we replace the potentiometer VR1 with an AC signal plus DC bias signal in any of the previous Figures 3 to 17, the voltage controlled attenuators can become an amplitude modulator circuit instead.

See Part 1, Part 2, and Part 3 of this series. The previous FET circuits pertained to voltage-controlled signal amplitude circuits. That is, the input signal’s amplitude can be changed at the output ...

Voltage conveyors and current conveyors represent two pivotal active building blocks in contemporary analog circuit design. Their unique signal processing capabilities allow for efficient voltage ...

Research paper titled “CMOS Interface Circuits for High-Voltage Automotive Signals” from University of Parma and Silis s.r.l. “The acquisition of high-voltage signals from sensors and actuators in an ...

For a long time, I have thought that pulse generator outputs should not have adjustable amplitude and offset. Instead, they should have an adjustable top value and a separately adjustable bottom value ...

I recently had the task of designing an analog front-end circuit for a microcontroller application. A full-bridge sensor in a standard configuration produced the input signal. An instrumentation ...

Negative group delay circuits represent an innovative frontier in electronic engineering, wherein the output signal appears to precede its input. This seemingly paradoxical behaviour is achieved ...

Infineon has introduced six automotive linear regulators, protected against 40 or 45V, and supplying 3.3 or 5V at up 500mA, some with enable, watchdog or reset circuits (see the table below). Picking ...

This circuit solves the problem of sending data over a cable with no free conductors. The data is OOK (on-off keying) modulated and superimposed on a high-frequency carrier so it can be sent over a ...

TOKYO--(BUSINESS WIRE)--Toshiba Electronic Devices & Storage Corporation ("Toshiba") has added a new eFuse IC, “TCKE712BNL,” to its line-up of eFuse ICs for repeated use that support functions to ...