grbl is stepper motor controller firmware for three-axis cnc machines, intended to run on Arduinos with a motor driver add-on board. Engineer in Wonderland cnc-related blogs are indexed here It is the ...

[Sebastian] and [Stefan Shütz] had a ISEL EP1090 CNC machine at home, sitting unused, and they decided to bring it to life. With pretty good mechanical specs, this CNC looked promising – alas, it was ...

ClearCore CLCR-4-13 is an industrial IO and motion controller that can be programmed using the Arduino IDE. It handles up to four axes of step-and-direction motion control (500kHz max step rate), and ...

WARNING: CNC systems are inherently dangerous. Use of this hardware and software is at your own risk. I am not an expert at CNC systems, THC's or electrical design. I'm just an embedded software guy ...

[Sebastian] and [Stefan Shütz] had a ISEL EP1090 CNC machine at home, sitting unused, and they decided to bring it to life. With pretty good mechanical specs, this CNC looked promising – alas, it was ...

Grbl is a no-compromise, high performance, low cost alternative to parallel-port-based motion control for CNC milling. This version of Grbl runs on an Arduino Mega2560 only. The controller is written ...

Intro:For 3D pinting, different filament (ABS, PLA etc) requires a suprising accurate temperature for extrusion to get the best results. Then, even using a specific type, different colours may work ...