This project aims to make a system to controll a toggle switch remotely. A User send iR signal with iR remote controller (Panasonic) to Arduino with iR receiver module, then the Arduino moves servo ...

When the car is powered on, the L293D motor shield and the IR receiver module are activated through the Arduino UNO board. The IR receiver then captures the IR signals. When the IR remote sends values ...

In this tutorial, we are going to interface E18-D80NK IR Proximity Sensor with Arduino. The E18-D80NK is an advanced low-cost IR Proximity Sensor with an obstacle detection range of 3 cm to 80 cm.

He put up a great tutorial on using an IR remote to do just about anything with everyone’s favorite microcontroller platform. [firestorm] used the Arduino IRremote library to decode the button ...

In my case I have used only 3 x 330Ω resistors, 3 leds and a TSOP4838 IR receiver module. You must check the datasheet before use the IR module to see which pins connect to the power supply and which ...

Arduino.org kondigt met Nordic op de Maker Faire Bay Area-show een nieuw basisbord aan, de Arduino Primo. Het Arduino-bordje bevat standaard ondersteuning voor bluetooth low energy, nfc, wifi en ...

This Device Controller project based on an 8-bit ATmega328P MCU that can control up to eight devices connected to its electromagnetic relays.

The main difference when using this method is that the IR signal is not inverted as it would normally be when using a more common modulated IR receiver module. All of the Arduino code you need to ...