Controlling Servo Motor using nRF24L01 wirelessly Once you are ready with the program upload the transmitter and receiver code (given below) on respective Arduino boards and power them up with USB ...

test code for joystick NRF servo control (will delete the temp file and replace with proper repo when done) - VelOBor/Joystick-servo-test ...

Connect the servo to +Vcc, GND, and pin 5 (PWM) of the receive arduino. Before installation, check the following The mounted position of the servo is where you want it to be upon initialization (pos = ...

Use the power amplified NRF24L01 with antenna on the receiving end to achieve a total 1KM of range with the transmitter. Use I2C connector on top of Arduino Pro Mini to give the receiver a display for ...

Why Choose nRF24L01 for Arduino Based Walkie Talkie? The main component of this project is the NRF24L01 RF module and Arduino Uno, which is the brain or processor. We have already learned how to ...

The project is a simple joystick control of a servo over a USB connection to an Arduino board. The 5V power of Arduino and Ground is connected directly to JR Sport ST47 standard servo while the ...

In this project, we create a joystick-controlled laser by connecting two servos to a joystick and using this setup as a pan-and-tilt controller for a laser pointer.

Arduino enthusiasts looking for a project to keep them busy may be interested in this new low-cost robotic hand which is being created using a little Arduino hardware and programming.