The Micro SD Card module has 6 pins; those are GND, VCC, MISO, MOSI, SCK, and CS. All the pins of this sensor module are digital, except VCC and Ground. -> GND is the ground pin of the micro sd card ...

The nRF24L01 is a small, low-price Wi-Fi verbal exchange module that keeps records over short distances. It uses radio waves to switch information at 2.4GHz, just like Wi-Fi however with decreased ...

So here’s the thing: Arduino’s built-in memory is tiny. If you’re just blinking LEDs, no problem. But the moment you try to log data, say battery usage, temperature over time, or GPS coordinates, ...

The single-board computer Arduino Uno Q gets a Qualcomm processor. It enables projects similar to a Raspberry Pi.

Pin 2 on the Arduino schematic is really GPIO2 on the NINA, therefore it should not be labeled GPIO34. This is confirmed by the fact that the pin numbering on the Arduino schematic matches the pin ...

If you are designing your own intelligent “Graden Computer” with an optional digital plant moisture sensor/water pump controller that lights an LED to alert the user when it is time to water a potted ...

Arduino Nicla Sense Env is a new sensor module with temperature, humidity, and gas (TVOC, NO2, O3) sensing that follows the launch of the Arduino Nicla Sense ME (Motion & Environment) module over ...

The FM receiver module is based on the TEA5767 [1, 2] chip. It is a well-known module that could be controlled via the I2C bus. It covers the FM frequency range from 76MHz to 108MHz. At the output, it ...

Time synchronization for wireless sensors is important for a proper interpretation of measurements, particularly for acceleration measurements to estimate mode-shapes. This paper presents a new time ...

Arduino is a well-known brand in the IoT industry. For the uninitiated, it is an open-source hardware and software company which designs and manufactures programmable electronic boards. It has a ...