Hello , me read this "And the best part is, it works! When the clock pin of the Arduino sketch is connected to the D+ pin of the AC6905, and the data pin of the Arduino is connected to the D- pin, the ...

In the Arduino schematic, for some reason pin 2 on the NINA-W102 is labeled "GPIO34". At first I thought I was mistaken, and that pin 2 on the Arduino schematic really is GPIO34 on the NINA, but that ...

Here is the schematic diagram of a Human-following robot circuit. This design incorporates three ultrasonic sensors, allowing distance measurements in three directions front, right, and left. These ...

Schematic drawing software for Arduino, Raspberry Pi, and other Single Board Computers (SBCs) is essential to developing electronics projects. When it comes to creating circuits on a SBC, it’s ...

VCC is the power supply pin of the soil moisture sensor that can be connected to 3.3V or 5V of the supply. But do note that the analog output will vary depending on the provided supply voltage. GND is ...

To build an FM receiver, developers can use highly integrated chips, such as the TEA5767 from NXP. Here we describe an FM receiver with a frequency range of 76 to 108 MHz and 2 x 3 W stereo sound ...

The FM receiver module is based on the TEA5767 [1, 2] chip. It is a well-known module that could be controlled via the I2C bus. It covers the FM frequency range from 76MHz to 108MHz. At the output, it ...