1 - Conecte o módulo LDR à protoboard. 2 - Conecte o módulo LDR ao Arduino utilizando 3 jumpers: 3 - Conecte o pino GND do módulo LDR ao pino GND do Arduino. 4 - Conecte o pino VCC do módulo LDR ao ...

In this project, we create a joystick-controlled laser by connecting two servos to a joystick and using this setup as a pan-and-tilt controller for a laser pointer. The following is excerpted from the ...

The YouTube channel DIY Builder has published and created a DIY Arduino laser engraver which is powered by an Arduino Nano development board and is fitted with a 200-250mW 650nm Laser Module. Check ...

I have made considerable progress on this project. I withdraw my initial assessment that this is a dead end. Read on. A friend is very involved with the support of local walking trails. His group ...

[Philip]’s Laser control Arduino shield. [Philip Nicovich] has been building laser sequencers over at the University of New South Wales. His platform is used to sequence laser excitation on his ...